How to Keep an Outdoor Water Heater From Freezing
Frost creeps across the patio bricks as the evening temperature drops toward thirty degrees. Keeping an exterior heater safe starts by leaving the electrical power turned on so built-in safety elements stay active, and wrapping exposed water pipes in thick foam insulation. Letting an indoor faucet run at a pencil-thin trickle on bitter nights keeps water moving so ice never forms inside the pipes.
The right approach depends on whether the house keeps electrical power, how deep the freeze gets, and whether the home sits empty. An outdoor system can usually handle a mild overnight frost on its own, but a power outage during a severe storm requires turning off the cold water supply and draining the lines dry. Taking a few simple precautions today prevents cracked metal and expensive water damage tomorrow.
Does an outdoor water heater protect itself from freezing?
Most modern outdoor tankless water heaters come with built-in freeze protection. This system relies on small electric heating blocks placed directly next to the heat exchanger (the internal metal coils that warm the water). When an internal sensor detects that outside air is dropping toward freezing, usually around 36 degrees Fahrenheit, it turns on these small heating pads. They radiate just enough warmth to stop ice from forming inside the core metal passages.
However, this built-in safety net has two major limits. First, it requires steady electricity. If a winter storm knocks out your power grid, the internal heating blocks turn off immediately. Second, this system only warms the parts inside the cabinet. It does not send heat into the exposed water pipes that connect underneath the unit.
Outdoor tank heaters work differently. They hold 30 to 50 gallons of hot water inside a heavily insulated drum. The water inside the main storage tank rarely freezes during typical cold snaps because the burner or electric element turns on to hold your set warmth. Still, the uninsulated plumbing lines running into and out of the tank remain fully exposed. If cold wind hits those bare pipes, they can freeze solid in just a few hours, even while the water inside the tank stays hot.
How do you prepare the unit before freezing weather hits?
Protecting an exterior water heater starts well before winter arrives. Taking time to insulate and shield your plumbing prevents burst pipes and costly emergency repairs.
- Install pipe sleeves over all exposed plumbing. Buy a pipe sleeve (a foam tube that covers exposed plumbing) sized to fit your water lines. Standard residential lines are usually half an inch or three-quarters of an inch thick. Slip the foam sleeve over both the cold water inlet pipe and the hot water outlet line right up to where they enter the heater cabinet. Seal every seam and joint with heavy-duty exterior tape so cold air cannot slip through gaps.
- Apply heat tape along vulnerable pipe sections. In areas where temperatures drop below freezing for days at a time, foam sleeves alone are not enough. Install heat tape (an electric warming cable wrapped around pipes) before adding the foam cover. Run the cable along the pipe according to the instructions on the package, secure it with electrical tape, and place the foam pipe sleeve directly over it. Plug the warming cable into an outdoor outlet protected by a ground-fault circuit interrupter.
- Seal gaps where pipes enter the house wall. Freezing drafts often blow straight into the wall opening behind the unit. Inspect where the plumbing enters your home siding. Fill visible gaps with expanding spray foam or exterior silicone caulk to keep freezing drafts from chilling the back of the pipes.
- Block direct freezing wind. Wind chill rapidly strips heat away from metal cabinets and plumbing lines. If your heater sits on an open, windy side of your home, install an outdoor-rated privacy screen or attach a manufacturer-approved metal wind baffle to the cabinet. Ensure the baffle leaves open clearance around all exhaust vents and air intake openings.
Should you leave a water faucet dripping overnight?
Yes, letting a faucet run a slight trickle overnight is one of the easiest ways to stop outdoor water lines from freezing. Moving water carries thermal energy from the underground water main, which usually sits between 50 and 55 degrees Fahrenheit. As long as water keeps moving through the system, ice crystals struggle to bond together and form a solid plug.
You do not need a heavy stream of water running down the drain. Aim for a steady trickle about the thickness of a pencil lead. If you have single-handle faucets, place the lever directly in the middle between hot and cold. This draws water through both the cold supply line and the hot water pipe that loops outside through your heater.
Choose a faucet located on the farthest wall from where the main water line enters your home. Running the furthest fixture ensures that water moves through the largest section of your plumbing network. Tankless heaters usually require a higher flow rate to fire up the main burner, so a pencil-lead trickle will not trigger the burner or run up your fuel bill. The moving water simply keeps the exterior plumbing lines from sitting stagnant in freezing air.
How do you drain the heater during a power outage?
When a severe storm knocks out your power, your outdoor tankless heater loses its built-in freeze protection. If outdoor temperatures drop below freezing and electricity will not return quickly, you must drain the unit manually. Water expands by about nine percent when it turns into ice, which splits internal copper tubing and breaks the heating core.
- Shut off power and fuel. Switch off the circuit breaker for the water heater or unplug the unit from its outdoor wall outlet. This prevents electrical damage when power returns. If you have a gas unit, turn the gas valve handle ninety degrees so it sits perpendicular to the gas pipe to shut off the fuel supply.
- Close the cold water supply. Find the cold water isolation valve on the pipe entering the bottom of the heater. Turn the handle perpendicular to the pipe to stop incoming water from entering the unit.
- Open indoor hot water taps to release pressure. Walk inside and turn on several hot water faucets completely. Leaving these taps open relieves pressure in your plumbing and breaks the vacuum, allowing trapped water in the outdoor unit to empty freely.
- Open the drain valves. Locate the service valves under the unit. Remove the protective caps from the drain valve (a small tap used to empty trapped water) on both the hot and cold lines. Screw a garden hose onto each drain port and route the other ends toward your yard or into buckets. Turn the drain valve handles to start draining the water.
- Remove internal drain plugs. Most tankless models feature small plastic or brass drain plugs at the base of the cabinet. Unscrew these plugs by hand or with a wrench to empty the heat exchanger (the internal metal coils that warm the water). Leave all drain ports and plugs open until power returns and temperatures rise above freezing.
What mistakes should you avoid during a cold snap?
During sudden freezes, hasty shortcuts can damage your equipment or create serious safety hazards. Keep these critical precautions in mind when temperatures plummet.
Never place an indoor portable space heater near an outdoor water heater. Standard indoor space heaters are built strictly for dry, enclosed rooms. Operating an indoor ceramic or fan heater outside exposes electrical wiring to rain, melting snow, and freezing condensation, creating an extreme risk of short circuits, electrical shocks, and house fires. If your plumbing passes through an attached garage or workshop, you can safely warm that indoor area instead. For instance, using a reliable electric heater for a garage with a thermostat keeps internal utility spaces above freezing without exposing electrical equipment to outside weather.
Along the same lines, never place an unrated space heater inside a drafty breezeway or exterior porch unless the unit is specifically rated for that environment. If you need supplemental heat for an enclosed porch where water lines enter the home, choose a listed heater for an enclosed porch that satisfies strict manufacturer clearances.
Never use an open flame torch to thaw frozen pipes. Applying a propane flame to copper or plastic plumbing can instantly boil trapped water, creating dangerous steam pressure that ruptures the pipe. Open flames also ignite dry house siding and wall framing. If an outdoor pipe freezes, wrap it in warm, damp towels or warm it slowly with a hair dryer held several inches away.
Never leave garden hoses attached to nearby outdoor spigots. A connected hose traps water inside the spigot valve. When that water freezes, it expands backward into the wall and splits the supply pipe feeding your water heater. Disconnect, drain, and store all garden hoses before freezing weather arrives.
Never unplug your outdoor water heater to save power during winter. Modern tankless units use very little electricity to run their internal frost sensors and heating elements. Unplugging the power cord disables this protection completely, leaving the internal core defenseless against sudden overnight freezes.
Frequently Asked Questions
Can you use a portable electric heater to thaw outdoor plumbing?
No, you should never place an indoor portable electric heater outside to thaw frozen pipes. Indoor units are not rated for wet outdoor conditions, and moisture from frost or melting ice can cause short circuits and dangerous electrical shocks. Instead, warm frozen pipes safely with a handheld hair dryer plugged into a ground-fault protected outlet or by wrapping the frozen line in warm, damp towels.
At what exact temperature will an outdoor water heater freeze?
Water freezes at 32 degrees Fahrenheit, but an outdoor water heater with active power usually prevents internal freezing down to temperatures between minus 5 and 5 degrees Fahrenheit. However, uninsulated pipes running into the unit lack internal heaters and can freeze whenever air temperatures drop below 28 degrees Fahrenheit for four or more hours. Strong freezing winds can cause exposed pipes to freeze even faster.
What should you do if the outdoor pipes already froze?
First, turn off the water heater and shut off the main water supply valve to prevent indoor flooding when the ice thaws. Open an indoor hot water faucet to relieve built-up pressure, then inspect all exposed outdoor pipes for visible cracks or bulges. If the pipes look undamaged, gently thaw them with a hair dryer or warm towels, starting from the faucet end and moving backward toward the frozen pipe. If you spot cracked pipes, call a licensed plumber before turning the main water back on.
Does tankless freeze protection work if you turn off the water?
Yes, the internal electric heating elements turn on based on air temperature even when the water supply is shut off. However, if water remains trapped inside the internal coils and the electrical power goes out, the unit can still freeze and crack. If you shut off your main water supply before leaving home during winter, you must also drain the heater completely so no trapped water remains inside.
Related guides: how to keep tankless water heater from freezing and how to keep rv water heater from freezing and will space heaters keep pipes from freezing.





















