Bestwinterproducts.com is reader-supported. When you buy through links on our site, we may earn an affiliate commission. Learn more

How to Measure Ski Poles With a Tape Measure?

Prime for Young Adults: check your eligibility on Amazon

Many skiers assume pole length means measuring only the bare shaft, but that leaves out part of the pole. Measure from the bottom tip to the top of the grip, following the pole’s full length, and don’t count the basket, the round disk above the tip.

The number tells you how long a pole is, but it doesn’t tell you by itself whether it suits your stance or how you ski. For a quick fit check, turn the pole upside down and hold it just below the basket: your elbow should bend to roughly a right angle while the grip touches the floor. Curved poles and the choice between two lengths can affect what feels comfortable, so start with the measurement and then check the fit.

Pole length runs from the tip to the grip

A ski pole’s length is measured from the very bottom tip to the top of the grip. The basket, the round disk above the pole tip, sits between those points but does not mark the end of the measurement. Measuring only the exposed shaft, or stopping at the basket, gives you a shorter number than the pole’s full length.

The tape should follow the pole’s length, not cut across a bend as if measuring a straight line between its ends. For a straight pole, keep the tape alongside the shaft. For a curved pole, guide the tape along the curve. This gives you the length of the pole itself rather than a shorter distance through the air.

Keep the pole steady on the floor or another flat surface while you measure. If the tip is sharp, point it away from your hands and feet. You do not need to take the pole apart or move the basket.

Measure from the bottom tip to the grip top

A tape measure can slip around the rounded grip or across the basket if you rush. Start at the bottom point and keep the tape in line with the pole. These steps help you get a clear reading at home.

  1. Set the pole down. Place it on a flat floor with the tip and grip easy to reach. Turn the pole so the side you plan to measure is facing up. If the pole curves, make sure the curve is not pressed flat against an edge.
  2. Find the bottom tip. Place the tape’s starting end at the lowest point of the pole tip. Do not start at the bottom edge of the basket. The basket is a disk above the tip, so starting there leaves part of the pole out of your measurement.
  3. Run the tape along the pole. Keep the tape beside the shaft and guide it around any curve. Avoid pulling it across the open space inside a curve. That shortcut measures a shorter line than the pole follows.
  4. Stop at the top of the grip. Read the tape where the upper end of the grip meets its top. Do not stop where the shaft enters the grip, because that leaves the handle out. Do not include a strap or any part that sticks above the grip.
  5. Read and record the result. Keep the tape from shifting while you note the measurement. If the marking falls between two lines, write down the closest clear marking and remember that the pole’s fit check matters more than a label alone.

If the tape is too short to reach the full pole in one pass, mark where the tape ends, then continue from that point. Keep the tape aligned with the pole, and add the two measured sections. A flexible tape may be easier to guide around a curved pole, but a regular tape measure works if you keep it from bowing away from the shaft.

Check the fit with the pole upside down

A measurement tells you the pole’s length. Your arm position gives you a practical check of whether that length suits your body. Try this in the boots or ski stance you expect to use, if you have them available, because your posture can change how the pole feels.

  1. Stand upright on a flat floor. Let your shoulders rest naturally and keep your arms at your sides. Avoid reaching up or leaning over to make a pole seem to fit.
  2. Turn the pole upside down. Put the grip on the floor and hold the pole just below the basket. The basket should be above your hand, with the pole tip pointing upward.
  3. Check your elbow. Let your arm bend naturally. Your elbow should make roughly a right angle, like the corner of a square, while the grip remains on the floor.
  4. Repeat with the other arm. Some people stand or hold their arms a little differently from one side to the other. Check both sides without forcing either elbow into position.

If your elbow bends much more than a right angle, the pole may feel short in this position. If your arm is nearly straight or your shoulder lifts, the pole may feel long. These are clues, not a promise that one measurement suits every skier. Your height, natural stance, and the kind of skiing you plan to do can affect what feels comfortable.

Keep your hand below the basket during this check. Holding the pole at the grip while it is upside down changes the position of your arm and can make the result misleading. The grip should rest on the floor, not your hand, so your elbow position is the part you can judge.

Follow the curve and leave out the basket

  • Curved poles: Lay the tape along the pole’s curve, following the path from the tip to the top of the grip. Do not measure straight through the open side of the bend. That gives you the distance between the ends, not the pole’s full length.
  • Straight poles: Run the tape parallel to the shaft. Keep it close enough that you can see the start and end points clearly, but do not let it angle away from the pole.
  • The basket: The basket does not count as either endpoint. Start below it at the pole tip, then continue past the basket and up to the grip. Do not start or stop at the basket just because it is a wide, easy-to-see part.
  • The grip: Include the full handle by stopping at its top. If you stop where the shaft enters the handle, your measurement leaves out the part your hand holds.
  • The strap: Leave the strap out. It is not part of the pole’s end-to-end length, and pulling it tight can shift the tape away from the grip.

If the pole is attached to a snow basket that makes it hard to place the tape at the tip, angle the pole so the bottom point is visible. Keep the tape’s starting end on the tip itself, not on the basket’s rim. There is no need to remove the basket for an ordinary length measurement.

For a reading you can repeat, measure the same pole again from the same two points. If the numbers differ, look for a tape that slipped at the tip, crossed a curve, or ended at the shaft instead of the grip top. Correcting the starting or stopping point usually explains a small mismatch.

Use your elbow and stance when the fit feels off

A pole can match a printed length and still feel awkward for you. If the upside-down check leaves your elbow far from a right angle, first repeat the check with the grip flat on the floor and your hand just below the basket. A changed hand position or a lifted shoulder can make a suitable pole seem too short or too long.

Then consider how you stand. If you naturally bend your knees or lean forward, your arms may sit differently than they do when you stand tall at home. Try the check in a relaxed, ski-like stance, but do not crouch deeply or reach to force the elbow into the position you want.

  • If the elbow bends well past a right angle: Compare with a shorter pole if one is available. A pole that is too long can make it harder to place the tip comfortably beside you.
  • If the elbow stays nearly straight: Compare with a longer pole if you can. A pole that is too short may make you reach down or feel cramped when placing the tip.
  • If the elbow is close to a right angle: The pole is in the useful range for this basic fit check. Notice whether your shoulders stay relaxed and whether you can hold the grip without reaching.
  • If the check looks right but the pole still feels awkward: Recheck your hand position, posture, and the pole’s measurement points. A number alone does not show how comfortably you can hold and place the pole.

When you are between two lengths, compare both poles in the same stance if you can. Keep the grip on the floor, hold below the basket, and look for the option that lets your elbow bend naturally without raising your shoulder or reaching down. Your intended use also matters, so do not assume that the longer or shorter option is always better.

If you cannot compare both lengths in person, use the pole’s stated measurement as a starting point, then confirm how the maker measures length and what size guidance it gives for your height and use. Length labels may not explain whether the number stops at the shaft or includes the grip. If that detail is unclear, check the manufacturer’s product information rather than comparing labels as if they all use the same endpoints.

A pole that feels wrong can also be the result of measuring it incorrectly, not a problem with your stance. Before deciding, repeat the end-to-end measurement and the upside-down fit check. If you still cannot tell which of two lengths suits you, ask a ski shop to help compare them in your normal stance.

Related guides: how to measure downhill ski poles and how to measure yourself for ski poles.

5
1 ratings
Scott Sample
WRITTEN BY
Scott Sample
Scott is a male editor who focuses on the field of photography. Based in Los Angeles, he has been reviewing cameras and providing guides on photography techniques for over 15 years. His work is appreciated for its technical accuracy and creative inspiration.